Bullard Powerhouse Uživatelský manuál stáhnout pdf

Bullard POWERHOUSE™ Charging Station

User Manual

for use with the Bullard T3™ Thermal Imager

Installation

The Powerhouse Charging Station is the perfect companion

for your T3 Thermal Imager. Designed to safely house and

charge the T3 and an accompanying battery, the

Powerhouse ensures that your T3 will always be ready for

action.

Using the Powerhouse as a free-standing unit:

NOTE

Although the Powerhouse is designed for

permanent vehicle installation, Bullard also

provides an optional adapter kit for unattached,

free-standing use. As a free-standing unit, the

Powerhouse cannot provide secure storage of

the thermal imager and its spare battery in a

vehicle in accordance with NFPA 1901-10-1.7.

Free-standing use is not recommended for

vehicles. The adapter kit includes a back cover

panel, rubber feet, an AC power adapter and

necessary wiring connectors.

Installation

The Powerhouse is designed to be mounted on any

convenient flat panel surface in a vehicle. When installed

and used in accordance with these instructions, the unit is

designed to comply with NFPA 1901-10-1.7 (see caution for

proper installation).

Location: Select a conveniently located, flat panel surface

of sufficient size to accommodate the unit. If the optional,

detachable transmitter/handle is to be used with the

thermal imager, be sure to allow sufficient room

(Figure 1)

for the handle which will protrude from the left side of the

unit when in place. The unit can be conveniently mounted in

various orientations; however, avoid mounting the unit in a

flat position with the open end facing either the front or

back part of the vehicle. These orientations do not comply

with NFPA 1901-10-1.7. As the required wiring enters the

unit from behind,

(Figure 2) it is necessary to have

sufficient access to the area behind the panel to install the

wiring. In addition, the unit is secured to the panel by four

(4) stainless steel flat head screws which are provided

with the unit. These may be secured to the panel by drilling

and tapping holes in the panel (if it is thick enough to

accommodate the threaded holes), or alternately by means

of the four (4) hex nuts provided.

16.5 cm

30.5 cm

7.62 cm

Allow 7.62 cm clearance above to remove imager

Allow clearance for

access to screws for

installation

22 cm

Figure 1

Unit projects 16.5 cm forward

from mounting panel

Figure 2

If using optional handle or

transmitter, allow 16.5 cm clearance

to left of unit.

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - User Manual

Bullard POWERHOUSE™ Charging Station User Manual for use with the Bullard T3™ Thermal ImagerInstallation5The Powerhouse Charging Station is the perfec

Strany 2 - Electrical Wiring

Electrical Wiring6Electrical Wiring: The unit is provided with a plug-inconnector fitted with a pair of wires for attachment to thepower supply wiring

Strany 3

Bullard POWERHOUSE™ Charging Station User Manual for use with the Bullard T3™ Thermal ImagerOperation7OperationThe Powerhouse charging station is desi

Strany 4 - Warranty

Strany 5

Strany 6

Strany 7

Strany 8